Race Drone At The River – Hand Launching Over Water And Flying Low – Full Flight No Edit

Race Drone At The River - Hand Launching Over Water And Flying Low - Full Flight No Edit
Wife and I met up with Tyler at the river this weekend to check out the old bridge. HOT day, summer is here for sure. Nice to get to the river for some flying and cool off a bit.
We had a lot of people around the bridge so had to take it easy, didn’t get too close and stayed clear. Still had some good flying and nice shots flying low over water.
Hand launch over water was a bit sketchy ! but I’ve hand launched a number of times so should not be any different.
Water was a bit difficult to see at times in the goggles, some areas were very calm and the water was dark and not easy to see the surface. But also some areas where the river was more shallow and could see the ripples on the surface.
Fun flight !

AirVuz – https://www.AirVuz.com/user/FireBlade
Instagram – https://www.instagram.com/JDogB1_FireBlade
FPVBook – http://www.fpvbook.com/FireBlade

Full open acro mode, accelerometer disabled.

Quadcopter: Custom build 5″ race quad using QAVR 220 upgraded frame. (thicker upper and lower plates, 3mm lower and 2mm upper, also upgraded fasteners and aluminum knurled standoffs)

PDB: Matek 5-in-1 3-5s
FC: OmniBus F4 Pro V2 Betaflight OSD
ESC: DYS blheli_s 30A V2 DShot600
Motors: Emax RS2205 2300kv
Blades: DalProp Cyclone T5050C
FPV Camera: RunCam Owl Plus 2 16:9 2.1mm
VTX: AKK Switchable Betaflight Q3 25mw to 800mw
Batteries: Tattu 1550mah 95c 4s
TX: FlySky i6x
FPV Goggles: Eachine EV800D
Antennas: TBS Triumph
DVR Receiver: Eachine RC840
DVR Camera: GoPro Session 5

Quad total weight without battery: 451g
Lipo battery weight: 171g (wrapped)

Race Drone At The River – Hand Launching Over Water And Flying Low – Full Flight No Edit