YeaTek Heat Bed Power Module Add-on Hot Bed Power Expansion Board MOS Tube High Current Load Module for 3D Printer
- APPLICATION: This high power module is a general add-on heated bed power expansion module for 3D printer. It can work with the Anet A8.
- MOTHERBOARD: The heat bed power module can be used in both Chitu motherboard and other open 3D printer motherboards.
- 25A MAXIMUM CURRENT: This high power module helps your 3D printer equipped with the Chitu controller board (capable of max 15A) become even more powerful. With this add-on module to board lead the maximum current up to 25A.
- GOOD PROTECTION: When using heated bed 3D printer for 12V power supply which may cause excessive current during times, with this module, it can well protect the connectors on the controller board from burning.
- PACKAGE INCLUDES: 2 x Heated bed power module (motherboard is not included) and 2 x Connection cable for input signal.
Size Name:2 Pack
Size: 6 x 5 x 3.1cm / 2.36 x 1.97 x 1.22″
Mounting holes: 3.2mm diameter, for M3 screws.
Max Current: 25A (Enhance heat dissipation) safe for prolonged times. ensure active cooling of the heatsink.
This module is based on power MOSFET and will allow PID control of the heated bed (DC-DC Relays usually do not allow this)
This module under the premise of normal cooling, found at I (Max) = 25A stable work situation, the process of using the current not exceed 25A.
2 x Heated Bed Power Expansion Module
2 x Connection cable for input signal
List Price: CDN$ 18.99
Price: CDN$ 18.99